PLEASE READ before purchasing. This will not work with the RING Indoor camera. Use this mount at your own risk. The outside of your window is exposed to the elements. You need to deep clean your window and push in firmly, to make sure that you have a good suction and check on it regularly.
With car vandalism on the rise, a customer wanted to mount the camera outside their apartment window on the 2nd floor.
This mount has a thick wall to handle the climate and a cutout on the bottom for water drainage.
It's tilted 20 Degrees to mount up high and can be slid in and out without the use of the grey mounting plate.
It can be used with the mesh screen if you have a gap of 2.75" or greater. If not, the mesh screen needs to be removed.
What's Included :
- 1x 3D printed Indoor Outdoor Suction Cup Mount for Ring Stick Up Camera
*** This is for the Stick Up camera and will not work with the Ring indoor camera. For the Ring indoor camera mount, please check out my other listing ***
* This listing is for the camera mount only; camera, wiring, or anything not listed above is not included, Only use pictures for reference. "
Indoor Outdoor Suction Cups Mount for Ring Stick Up Camera
Please note that layer lines will be present and may have minor imperfections, but will not affect functionality. This is due to the 3D printing process.
Not all 3D prints are the same. Our 3D prints are made with quality PLA+ filaments. PLA+ is stronger and more rigid than standard PLA, as well as having a higher level of toughness.
We don't use Generic filament or Standard filament; they are cheap and low quality, and will not last.
The majority of our prints are thick and solid, unlike the thin and hollow prints found in many other products.